You need to remember, dry clearance will seam excessive, wet.

Will you be mass producing these or is this just for your personal ride?

W Gunnison River Dr, Delta, CO Get directions. PhoneFaxEmail [email protected] Additional links. See all locations operated by owner. Mar 09, I have made some Delrin bushings for Corvettes and Vipers.I shoot for".Press in housing then ream or bore.I wouldn't use a zinc plated axle,if you need corrosion resistance use stainless and make provisions to shrubremoval.buzz will help to flush out sand and debris that will imbed in the bushing and abrade the axle.

It seems I'm using Delrin, or Anyway, everything's put back together. Gone are the original squeaky (and rusty) bearings. The greased Delrin bushings feel awesome when actuating the sway bar by hand.

I am able to grease the bushings I make and it does help for both use and assembly.

The one downside is that the bushing housing alignment is crucial (the old bearings were spherical, so alignment wasn't that important).

Sep 01, This is the property details for Flint, Delta, CO This horse property is in the Delta subdivision and the neighborhood. The current listing price for this horse property is, and has been listed by Telluride Realty, LLC.

This horse property has 5 bedrooms and 5 total baths. The MLS number of this property is A huge 2,+ home on +acres. May 28, Shaft is 60mm Stainless bearing material is Delrin and I allowed about mm clearance as installed in the rudder tube.

Well, the boat is back once again with a jammed rudder and I suspect the problem is the upper Delrin bushing which appears to be a size for size fit. I suggested boring the upper bushing out with similar clearance to eliminate.